HPE FlexFabric 5950 Series Configuration Manual page 402

To configure RIPng between an MCE and a VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter
RIPng view.
3. Redistribute remote site
routes advertised by the PE.
4. Return to system view.
5. Enter interface view.
6. Enable RIPng on the
interface.
C onfiguring OSPFv3 between an MCE and a VPN site
5 7 9 B
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public
network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of
different IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between an MCE and a VPN site:
Step
1. Enter system view.
2. Create an OSPFv3 process
for a VPN instance and
enter OSPFv3 view.
3. Set the router ID.
4. Redistribute remote site
routes advertised by the
PE.
5. Return to system view.
6. Enter interface view.
7. Enable OSPFv3 on the
interface.
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol
[ process-id ] [ allow-ibgp ]
[ allow-direct | cost cost-value |
route-policy route-policy-name ]
*
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
router-id router-id
import-route protocol [ process-id |
all-processes | allow-ibgp ]
[ allow-direct | cost cost-value |
nssa-only | route-policy
route-policy-name | tag tag | type
type ] *
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
394
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
By default, no routes are
redistributed into RIPng.
N/A
N/A
By default, RIPng is disabled.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
common OSPFv3.
Deleting a VPN instance also
deletes all related OSPFv3
processes.
N/A
By default, no routes are
redistributed into OSPFv3.
N/A
N/A
By default, OSPFv3 is disabled on
an interface.