HPE FlexFabric 5950 Series Configuration Manual page 136

Current state: UP
Line protocol state: UP
Description: Tunnel3 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1496
Internet address: 9.1.1.1/24 (primary)
Tunnel source unknown, destination 3.3.3.9
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Verify that two CRLSPs exist on Switch A, one with the output interface VLAN-interface 1 and the
other with the output interface VLAN-interface 4.
[SwitchA] display mpls lsp
FEC
1.1.1.9/3/34311
1.1.1.9/3/34312
10.1.1.2
30.1.1.2
Tunnel3
Backup
# Display the paths used by the two CRLSPs on Switch A.
[SwitchA] display rsvp lsp verbose
Tunnel name: SwitchA_t3
Destination: 3.3.3.9
Tunnel ID: 3
LSR type: Ingress
Setup priority: 7
In-Label: -
In-Interface: -
Nexthop: 10.1.1.2
Include-Any: 0
Mean rate (CIR): 0 kbps
Path MTU: 1500
RRO number: 6
10.1.1.1/32
10.1.1.2/32
2.2.2.9/32
20.1.1.1/32
20.1.1.2/32
3.3.3.9/32
Fast Reroute protection: None
Proto In/Out Label
RSVP -/1150
RSVP -/1151
Local -/-
Local -/-
Local -/-
-/-
Flag: 0x00 (No FRR)
Flag: 0x00 (No FRR/In-Int)
Flag: 0x20 (No FRR/Node-ID)
Flag: 0x00 (No FRR)
Flag: 0x00 (No FRR/In-Int)
Flag: 0x20 (No FRR/Node-ID)
128
Interface/Out NHLFE
Vlan1
Vlan4
Vlan1
Vlan4
NHLFE1026
NHLFE1028
Source: 1.1.1.9
LSP ID: 30106
Direction: Unidirectional
Holding priority: 7
Out-Label: 1137
Out-Interface: Vlan1
Exclude-any: 0
Include-all: 0
Mean burst size (CBS): 1000.00 bytes
Class type: CT0