Table of Contents
Advertisement
Chapter 2 - Installation
2.5
Cable Connections
The BreezeMAX Extreme is provided with sealing glands on all the cable
connectors. The DATA/DC IN/OUT, and GPS IN/OUT cables are to be connected
to the BTS by inserting the cable connector through the sealing gland. The DC
power cable is supplied with a sealing gland that should replace the existing
sealing gland provided with the BTS.
For the GPS ANT connector, a weather-proof metal cap seals the connection. If
this connector is not used, do not remove the metal cap. In case there is only a
rubber cap on this connector, use additional sealing methods to protect this
connection. Use high quality sealing material such as Scotchfil™ Electrical
Insulation Putty from 3M (or equivalent) over-wrapped with either Super 33+ or
Super 88 vinyl Electrical Tape (or equivalent) to ensure IP-67 compliant protection
against dust and water.
A dedicated tool is supplied for fastening the sealing glands (see
Sealing Gland
Fastening Tool
Figure 2-19: BTS with Sealing Gland and Gland Fastening Tool
BreezeMAX Extreme
56
Cable Connections
Figure
2-19).
Sealing
Gland
System Manual
Advertisement
Table of Contents
