Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.6.2.9
Service Groups
A Service Group defines the DHCP mode to be used for acquiring IP address
configuration for the MS provisioned with the relevant Service and, if applicable,
for other devices behind the MS. It also defines additional parameters that affect
the communication between the ASN-GW and an external DHCP server, if
applicable. The Service Group's parameters includes also the Attributes to be
used for communication with a RADIUS Accounting server.
NOTE
All MSs using IP-CS service flows will be de-registered so that clients will be forced to renew their IP
bindings in the following cases:
1. DHCP Type is changed and the old type is other than None (if it is none, the BS just forwards
DHCP traffic without taking any action).
2. DHCP Type hasn't changed, but it is configured as Server and at least one of the following
networking values has changed:
Pool IP address
Pool Subnet Mask
DHCP IP Address
A DNS IP Address
Lease Time
CPE Management Server
Default Gateway
Up to 10 different Service Groups can be defined.
In addition to managing Service Groups, the Service Groups Menu enables also
viewing the Lease Times (see
Each Service Group includes the following parameters:
4.6.2.9.1
Service Group ID
This is an auto-sequential number from 1 to a maximum of 10, generated
automatically during creation of a new Service Group.
4.6.2.9.2
Service Group Name
The Name of the Service Group. A unique string of 1 to 32 characters.
4.6.2.9.3
DHCP Type
The DHCP operation mode supported by the unit:
BreezeMAX Extreme
"Show DHCP Lease Times" on page
141
ASN-GW Menu
147)
System Manual
Advertisement
Table of Contents
