Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.10.2 Select
Use this option to select the viewing and configuration mode for a specific
Antenna. The following options are available for the selected Antenna:
4.10.2.1
Show
Select this option to view the relevant parameters of the selected Antenna. The
displayed information is the same as described in
above.
4.10.2.2
Update
This option is applicable only for external Antennas. Select this option to
configure/modify the following parameters of the selected Antenna:
Antenna Gain (dBi)
Beam Width (degrees)
Antenna Polarization
NOTE
For a Dual Slant antenna only Antenna 1 should be configured. The read-only configuration of
Antenna 2 will be copied from the configuration of Antenna 1.
4.10.2.2.1
Antenna Gain (dBi)
The gain of the antenna in dBi.
The range is from 0 to 40 dBi.
The defaults is 14 dBi.
NOTE
For units using a Country Code with limitation on the maximum allowed EIRP, the configuration
range for Antenna Gain depends on the currently configured values for Tx Power and Bandwidth.
For more details refer to
For such units using two antennas per sector, the gain of both antennas must be set to the same
value.
4.10.2.2.2
Beam Width (degrees)
The antenna's beamwidth in degrees.
Available values are 60, 90, 120 and 360 degrees.
BreezeMAX Extreme
"Tx Power" on page 168
209
Show Summary (Section
.
Antenna Menu
4.10.1)
System Manual
Advertisement
Table of Contents
