Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Show Spectrum Analyzer Results
4.7.2.2.3.1
Show
Select this option to display the current Spectrum Analyzer parameters
4.7.2.2.3.2
Update Spectrum Analyzer General Parameters
Select this option to define test parameters and initiate a new test. After properly
completing the definition of test parameters the test is initiated automatically. The
configurable test parameters are:
4.7.2.2.3.2.1 Spectrum Analyzer Support
Select the Enable option to start a new test. The default is Disable.
4.7.2.2.3.2.2 Start Frequency
The lowest frequency (in MHz) in the range of frequencies to be tested. Must be in
the range from Minimum Frequency+1/2 Bandwidth up to a maximum of
Maximum Frequency-1/2 Bandwidth, using a resolution of 2.5 MHz for a 5 MHz
Sector Bandwidth or 5 MHz for a Sector Bandwidth of 10 or 20 MHz. For more
details refer to
The default is the lowest frequency that can be supported using these rules.
4.7.2.2.3.2.3 Stop Frequency
The highest frequency (in MHz) in the range of frequencies to be tested. Must meet
the same configuration rules as defined for Start Frequency. In addition, Stop
Frequency cannot be lower than Start Frequency.
The default is the highest frequency that can be supported using these rules.
4.7.2.2.3.2.4 Scanning Time
The test duration in seconds at each of the scanned frequencies.
The available range is from 1 to 3600 seconds, and the default is 60 seconds.
The test will start automatically after configuring the Scanning Time.
4.7.2.2.3.2.5 Step
The resolution of frequencies to be tested, in multiples of 5 MHz (5, 10, 15,...MHz).
4.7.2.2.3.3
Show Spectrum Analyzer Results
Select this option to view the last (if any) test results. There are two viewing
options:
Show results sorted by frequency
Show results sorted by median RSSI
BreezeMAX Extreme
"Frequency" on page
182
164.
Sector Menu
System Manual
Advertisement
Table of Contents
