Table of Contents
Advertisement
Chapter 2 - Installation
Hole for
High-gain
GPS antenna
Lightning
arrestor
Use the 25m GPS cable to connect the lightning arrestor on the GPS bracket to
4
the second lightning arrestor installed near the BTS (see
Lightning Arrestor" on page
GPS ANT connector on the BTS.
Hand-tighten the connector on the interface cable using the locking ring for
5
securing the connection.
Use the supplied metal bands to assemble the bracket on a pole.
6
Fix the cable onto the pole using a plastic strip.
7
To connect BTSs in GPS chaining:
Refer to
Connect one end of the CAT5 cable to the GPS OUT connector of the BTS with
1
the GPS antenna, and the other end to the GPS IN connector of the chained
(target) BTS.
To chain an additional BTS, connect one end of the CAT5 cable to the GPS
2
OUT connector of the chained BTS, and the other end to the GPS IN connector
of the added (target) BTS.
BreezeMAX Extreme
Figure 2-16: Bracket for High-Gain GPS
Figure
2-17.
41). Connect this second lightning arrestor to the
52
GPS Installation
Holes for
metal bands
"Installing a
System Manual
Advertisement
Table of Contents
