Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.6.2.11.4
Unknown Address Forwarding Mode
The Unknown Address Forwarding Mode parameter determines the mode of
controlling the flow of information from the backbone to the wireless media. Select
from the following options:
1 - Forward: Enables the transmission of all packets, except unicast packets sent
to addresses that the unit recognizes as being on its wired backbone side.
2 - Discard: The unit will transmit unicast packets only to those addresses that it
knows to exist on the wireless link side.
4.6.2.11.5
QoS Type
The QoS Type parameter determines the QoS type to be used for multicast and
broadcast messages and for unknown connections. In the current release the
available options are BE (Best Effort) and NRT (Non Real Time).
The availability/range of the following parameters depend on the selected QoS
Type:
4.6.2.11.6
CP
The Committed Priority.
For BE QoS CP is not configurable and is set to 0.
For NRT QoS the supported range is from 1 to 2.
The CP parameter affects the Committed Time (CT) as follows:
CP (Committed Priority)
0
1
2
Maximum Latency is equal to CT.
4.6.2.11.7
QoS Parameters (CIR/MIR)
The availability of specific QoS parameters depend on the selected QoS Type as
follows:
QoS Type
BE
BreezeMAX Extreme
Table 4-10: Committed Time
CT (Committed Time)
1000ms
2000ms
60ms
Table 4-11: QoS Parameters
QoS Parameters
MIR
151
ASN-GW Menu
System Manual
Advertisement
Table of Contents
