Table of Contents
Advertisement
Chapter 4 - Operation and Administration
In Single sector Dual BS Operation Mode, the sector operates using two adjacent
channels. Therefore the selection is based on the statistics gathered from the two
adjacent channels. Also, once a degradation is detected on one of the channels,
instead of stopping the operation in both channels the DCS first verifies if the
other adjacent channel (on the other side of the "good" channel) has better
conditions then the "bad" channel. The verification is performed using the average
NI of the current channel, and the NI measurements of the new channel. If the
channel has better conditions then this channel is selected. This process ensures
that service to MSs served by the "good" channel is not interrupted. If not, then
the operation of both channels is stopped and the new channels selection
mechanism is triggered.
The DCS Menu includes the following options:
Show
Update DCS General Parameters
Show DCS Scanning Results
4.7.2.2.2.2.1 Show
Select this option to display the following:
Current DCS Support
Configured DCS Support
The following will be displayed only if Configured DCS Support is set to Enable:
Current NI Channel Measurement Interval (sec)
Configured NI Channel Measurement Interval (sec)
Current SNR Averaging Factor (%)
Configured SNR Averaging Factor (%)
Current SNR Degradation Percentage (%)
Configured SNR Degradation Percentage (%)
Current Channel Tracking Interval (sec)
BreezeMAX Extreme
177
Sector Menu
System Manual
Advertisement
Table of Contents
