Table of Contents
Advertisement
Chapter 2 - Installation
Groove for
metal bands
Tilt control
screws (x2)
Holes for fastening
screws (x4)
To install the Carriage on a 1.5''-4'' pole:
Assemble the tilt bracket on the BTS and fasten its four screws (see
1
"Assembling the Tilt Bracket on the BTS" on page
Install a lightning arrestor on the carriage as described in
2
Lightning Arrestor" on page
Thread the four rods through the carriage.
3
Attach the carriage and the clamps to the pole and tighten on both sides using
4
the supplied washers, spring washers and nuts. Apply torque of
80 [Lib*In] = 9 [N*m].
Insert the tilt control screws into the middle-side hole of the carriage on both
5
sides.
BreezeMAX Extreme
Holes for wall
mounting screws (x4)
Holes for lightning
arrestor (x4)
Figure 2-8: BreezeMAX Extreme Pole Mount Carriage
41.
43
BTS Installation
Holes for pole
mounting rods (x4)
39).
"Installing a
System Manual
Advertisement
Table of Contents
