Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Access Level
Installer
Monitor
4.5.5.2
Reset BTS
Select this option to reset the BTS. To avoid unintentional reset, you will be
prompted to confirm the reset request. Changes to some of the configurable
parameters are applied only after reset.
Refer to
are changeable in run time and which changes are applied only after reset.
4.5.5.3
Reset to BTS Factory Defaults
Select this option to set the BTS parameters to their factory default values. All
parameters, excluding the access Passwords, BTS General parameters and BTS
Connectivity parameters (required to enable remote management of the BTS) will
revert to their default values after the next reset. Note that AAA servers and
Authorized Managers will be deleted. Services (if applicable) are not deleted.
Refer to
values of all parameters.
4.5.5.4
SW Version Control
The BTS can contain two SW versions:
Operational: Each time the BTS resets it will reboot using the version defined
as Operational.
Shadow: Normally the Shadow version is the backup version. Each time a new
SW File is downloaded to the BTS, it will be stored as a Shadow version,
replacing the previous Shadow Version.
The typical process of upgrading to a new SW version includes the following steps:
Download the new SW File to the BTS. It will be stored as the Shadow version.
1
Reset and run the BTS from its Shadow version. Note that at this stage, if a
2
reset were to occur, the BTS will return to the previous Operational version.
If you want to continue using the new version, swap the Shadow and
3
Operational versions. The new (currently running) version is now defined as
BreezeMAX Extreme
Table 4-4: Default Passwords
"Parameters Summary" on page 223
"Parameters Summary" on page 223
Default Password
installer
monitor
for information on which parameters
for information on the factory default
105
BTS Menu
System Manual
Advertisement
Table of Contents
