Table of Contents
Advertisement
Chapter 2 - Installation
Use the supplied metal bands to assemble the bracket on a pole.
4
Fix the cable onto the pole using plastic strips.
5
To install the high-gain GPS antenna:
NOTE
Do not over-tighten or use a tool for tightening the cables, to avoid stripping the connectors.
Place the bracket on a flat surface and thread the GPS antenna through the
1
3/4" hole of the bracket. Hand-tighten the fastening nut.
If you use a GPS cable longer than 3m, assemble the lightning arrestor on the
2
bracket, with the screws facing the bracket.
Connect one end of the 0.5 m cable to the lightning arrestor and the other end
3
to the GPS antenna.
BreezeMAX Extreme
Hole for GPS
antenna
Holes for
metal bands
Figure 2-15: Bracket for Basic GPS
51
GPS Installation
System Manual
Advertisement
Table of Contents
