Appendix A - Terminal Setting And User Commands; Hyperterminal Parameters; Logging In - Polycom 3150-30828-001 User Manual

Appendix A – Terminal Setting
and User Commands
The Polycom® RSS™ 4000 supports command settings for the configuration
of equipment and troubleshooting. There are two ways of using commands
to configure settings: one is to connect to the Polycom® RSS™ 4000's serial
port and use an emulation program like Hyperterminal; the other is to use
telnet. The format of commands is the same in both cases. The following
explains how to use commands to perform settings with hyperterminal
commands only, but the commands in telnet work the same way.

Hyperterminal Parameters






The following additional parameters may need to be set if required by the
emulation software:





Logging in

After completing the above settings and successfully enabling the endpoint
emulation software, press the Carriage Return/Enter key to enter the login
interface.
The login interface displays various types of information about the software
and prompts the user to enter the login password. Please enter the login
password and press Enter.
Port: COM1 (confirm on the basis of the port used on the PC )
Baud rate: 9600 bps
Data: 8
Parity: none
Stop bit: 1
Echo off for local input
DEL key and Backspace key settings
Carriage return/line feed
Endpoint emulation types are "automatic" and "ANSI"
5
5-1