Table of Contents
Advertisement
will change to
.
Repeatedly clicking on the button on the left
recording operation, and the buttons will change to
Clicking on the button on the right
on this button will disconnect the H.323 connection.
Each H.323 connection status display includes: the IP address of the H.323
endpoint that establishes a connection with Polycom® RSS™ 4000, the H.323
ID, the time the connection was established, the recording room joined,
recording status, packet loss rate, the audio and video protocols, and
whether it is H.239 enabled. Recording status has three kinds of displays.
When it shows as "Idle", it means it has not started recording or playing
video. When it shows "Playback", it means it is in the process of playing
video. When it shows "Recording", it means it is in the process of recording.
Packet loss rate shows the statistics for the packet loss between the endpoint
and the uplink with the Polycom® RSS™ 4000, tabulated once every 5
seconds.
The H.239 column displays whether or not H.239 is enabled on the endpoint, but does
not show if the Polycom® RSS™ 4000 is recording or playing back H.239. It only
identifies if this endpoint has H.239 capability.
H.323 connection status display is refreshed every 30 seconds.
Polycom® RSS™ 4000 User Guide
will pause/continue the
.
will stop recording. Clicking again
2-43
Advertisement
Table of Contents
