Table of Contents
Advertisement
parameters. In the Point to Point Settings page, the administrator can set
recording room name, recording room number, recording room protocol,
and recording room rate, as well as whether nor not to record H.239 dual
video, request I-frame intervals during the recording process, whether or not
to stream the video, and recording rights and viewing rights.
On the "Point to Point Settings" page, the administrator can view all current
recording room names, recording room numbers, H.239 dual video
configurations, recording room rate, and current number of endpoints in the
recording room, as well as recording room status, as shown below:
Figure 2-34
Point-to-point recording Settings Page
Recording room name, recording room number, and recording room rate are
parameters used to identify the recording room. Whether or not to enable
H.239 dual video identifies whether or not to display people video and
content during web playback. Participants shows the current number of
people in the recording room, 0/2 indicates that no participants have joined
the recording room. 1/2 indicates that one participant has joined the
recording room. 2/2 indicates that two participants have joined the recording
room. There are two kinds of recording room states: idle and recording.
"Idle" means that recording has not started, and "Recording" means that
recording has started.
Create Recording Room
Click the "New" button on this page, and the page will jump to the Add
Recording Room page, as shown below:
Figure 2-35
Point-to-point Recording Room Settings
Polycom® RSS™ 4000 User Guide
2-31
Advertisement
Table of Contents
