Comtech EF Data CSAT-5060 Installation And Operation Manual page 87

CSAT-5060 50 Watt C-Band Transceiver
Remote Control
Arguments
for
Command Command
(Instruction or
Parameter Code and Response
Type qualifier) to Query
Concise N/A 31 bytes,
Configuration alpha
Status numerical
Concise LNA N/A 4 bytes,
Status alpha
numerical
Concise N/A 10 bytes,
Utility Status alpha
numerical
Description of Arguments
Note that all arguments are ASCII
numeric codes between 48 and 57.
Query only.
Used to Query the Configuration status of the CSAT
Example: CCS=uuuu.udddd.daa.aabb.bbotamrncfx'cr''lf'
where:
uuuu.u = Tx frequency
dddd.d = Rx frequency
aa.aa = Tx attenuation
bb.bb = Rx attenuation
o = online status, 0 = OFFLINE, 1 = ONLINE
t = transmitter status, 0 = OFF, 1 = ON
a = amplifier status, 0 = OFF, 1 = ON
m = Tx mute status, 0 = Unmuted, 1 = Muted
r = receiver status, 0 = OFF, 1 = ON
n = Rx mute status, 0 = Unmuted, 1 = Muted
c = cold start, 0 = Disabled, 1 = Enabled
f = auto fault recover, 0 = Disabled, 1 = Enabled
x = external reference present, 0 = NO, 1 = YES
Query only.
Used to Query the LNA status of the CSAT
Example: CLS=abbc'cr''lf'
where:
a = LNA Current 0=OFF, 1=ON
bb = Current window in %
c = LNA Fault Logic 0=OFF, 1=ON
Query only.
Used to Query the Utility status of the CSAT
Example: CUS=brrru.ud.d'cr''lf'
where:
b = baud rate, 1 = 1200, 2 = 2400,
3 = 4800, 4 = 9600, and 5 = 19200
rrr = reference adjust
u.u = Up converter slope adjust
d.d = Down converter slope adjust
Response to
Command
(Slave to Master)
N/A
N/A
N/A
A-15
MN/CSAT506050.IOM
Query
(Instruction
code and Response to query
qualifier) (Slave to Master)
CCS? CCS=x....x (see description for
details of arguments)
CLS? CLS=x....x (see description for
details of arguments)
CUS? CUS=x....x (see description for
details of arguments)
Revision 0