Redundancy Controller Auto/Manual; Redundancy Controller Toggle; Set Physical Address - Comtech EF Data CSAT-5060 Installation And Operation Manual

CSAT-5060 50 Watt C-Band Transceiver
System Operation
3.3.16 R
EDUNDANCY
The Operating mode of the Comtech EF Data Redundant Switch Unit (RSU-
5060) can be set via a command to the ONLINE CSAT. The RSU-5060 initializes
to the AUTO mode when power is first applied.
• In AUTO mode the RSU-5060 monitors the state of the two CSATs and
• In MANUAL mode, the RSU-5060 will only switch the position of the Tx
Associated Remote Command(s):
Example(s):
3.3.17 R
EDUNDANCY
The User can cause the RSU-5060 Redundant Switch Unit to switch the position
of both the Tx and Rx transfer switches using this command.
• If the RSU-5060 is in AUTO mode, the command will only cause a
• If the RSU-5060 is in MANUAL mode, the command will cause a
Associated Remote Command(s):
Example(s):
3.3.18 S P
ET HYSICAL
The Remote (Physical) address to which the CSAT will respond can be set to any
value between 0001 and 9999. (The factory default is 0001)
Associated Remote Command(s):
Example(s):
C A
ONTROLLER
will automatically switch the OFFLINE unit online if the ONLINE unit
faults.
and Rx transfer switches when commanded to do so via either the RTG=
command or via Pin V on the 'M&C Control' connector (J5) on the RSU-
5060. The user sets AUTO mode by sending a '1' in the data field and
MANUAL mode with a '0' in the data field.
C T
ONTROLLER OGGLE
switchover if the OFFLINE unit is currently UNFAULTED.
switchover independent of the state of the OFFLINE unit.
A
DDRESS
/M
UTO ANUAL
RAM=
RAM=1
RTG=
RTG=
SPA=
SPA=0001
3–9
Revision 0
MN/CSAT506050.IOM