Siemens SINAMICS G110D Operating Instructions Manual page 132

Functions
6.10 Quick Stop function
The front edge of the load is detected by the sensor, which initiates the Quick Stop function.
Figure 6-17
The load is then slowed down and stopped.
Figure 6-18
There are two sensors on the conveyor section, so that the Quick Stop function can stop the
conveyor section in either direction when a load is detected.
How does it work?
The Quick Stop function is configured using BICO parameters and they are explained in the
table below.
Table 6- 51 Quick Stop parameters
Parameter Description
P0881 Quick Stop function Input 1 is ON
P0882 Quick Stop function Input 2 is ON
P0883 Quick Stop override
132
Conveyor example 2
Conveyor example 3
Remarks
Allows Quick Stop source 1 command to be selected using
BICO. The signal is expected to be active low (default setting
P0886 = 2).
Allows Quick Stop source 2 command to be selected using
BICO. The signal is expected to be active low (default setting
(P0886 = 2).
Allows Quick Stop override command source to be selected
using BICO. The signal is expected to be active high.
Operating Instructions, 2009-05-15, A5E02385577A AB
SINAMICS G110D