Standards; A.2 Standards - Siemens SINAMICS G110D Operating Instructions Manual

EMC Phenomenon
Voltage Unbalance
Frequency Variation
Commutation Notches
A.2

Standards

A.2.1 Standards
Standards
European Low Voltage Directive
The SINAMICS G110D product range complies with the requirements of the Low Voltage Directive
2006/95/EC. The units are certified for complaince with the following standards:
EN 61800-5-1 — Semiconductor inverters –General requirements and line commutated inverters
EN 60204-1 — Safety of machinery –Electrical equipment of machines
European Machinery Directive
The SINAMICS G110D inverter series does not fall under the scope of the Machinery Directive.
However, the products have been fully evaluated for compliance with the essential Health & Safety
requirements of the directive when used in a typical machine application. A Declaration of Incorporation
is available on request.
European EMC Directive
When installed according to the recommendations described in this manual, the SINAMICS G110D fulfils
all requirements of the EMC Directive as defined by the EMC Product Standard for Power Drive Systems
EN 61800-3
Underwriters Laboratories
UL LISTED POWER CONVERSION EQUIPMENT for use in a pollution degree 2 environment.
ISO 9001
Siemens plc operates a quality management system, which complies with the requirements of ISO 9001.
Certificates can be downloaded from the internet under the following link:
http://support.automation.siemens.com/WW/view/de/22339653/134200
SINAMICS G110D
Operating Instructions, 2009-05-15, A5E02385577A AB
Standard Level
EN 61000-2-4 3 % Negative Phase
Sequence
Class 3
EN 61000-2-4 Nominal 50 Hz or 60 Hz
(± 4 %)
Class 3
EN 60146-1-1 Depth = 40 %
Class B
Area = 250 % x degrees
Appendix A

A.2 Standards

Performance
Criterion
A
A
A
183