Mounting: Horn Antenna And Shielded Rod Antenna; Mounting: Waveguide Antenna - Siemens SITRANS LR200 Instruction Manual

Mounting: Horn Antenna and Shielded Rod Antenna.

The end of the horn should protrude
a minimum of 10 mm (0.4") to avoid
interference with the nozzle.

Mounting: Waveguide Antenna

This option is recommended for products with ε
page 97 for the related propagation factor.
Page 56 SITRANS LR 200 (PROFIBUS PA) – INSTRUCTION MANUAL
10 mm (0.4")
vent hole
minimum 80 mm (3")
Notes:
• This option is recommended only for clean
liquids, and only on vessels without an agitator,
with no turbulence.
• Horizontal stress on this antenna must be
avoided, otherwise mechanical support may be
required.
• Process temperature and pressure capabilities
are dependent upon information on the process
device tag. The reference drawing listed on the
tag is available upon request.
The end of the shield should protrude
a minimum of 10 mm (0.4") to avoid
interference with the nozzle.
Propagation Factor
lower than 3. See
r
10 mm (0.4")
on
7ML19985HP01