Output; 3.1. Aifb1 - Siemens SITRANS LR200 Instruction Manual

3. Output

3.1. AIFB1

Static Revision No.
The revision level of the static data associated with Analog Input Function Block 1.
The Static Revision No. is updated whenever a standard profile configuration
parameter is changed.
3.1.1. Target Mode
Used to request an operating mode from the Function Block.
Values
Open the menu Device – Simulation, go to Function Block – AIFB1 or 2, click on
the tab Simulation Output, and select a target mode. Then click on the tab
Simulation (Measured Value), and enable or disable Simulation.
3.1.2. Unit
Engineering unit to be displayed with the output value.
3.1.3. Filter Time Constant
The time constant for the damping filter. The engineering unit is always in
seconds. (This is an exponential filter: when a change occurs at the input, the
output will be at 63.2% of the change in one time constant, and will be at full
change after 5 time constants.)
3.1.4. Function
Used to select between the different level block outputs (Volume/Level, Level,
Distance in Sensor units, Distance in Level units).
3.1.5. Batch Information
These 4 parameters are intended to be used in Batch Applications conforming to
IEC 61512 Part 1 (ISA S88). Other applications do not require these values, which
are only stored in the Function Block.
3.1.5.1. Batch ID
Identifies a certain batch to allow assignment of equipment-related
information (for example faults, alarms) to the batch.
3.1.5.2. Batch Unit
Identifies the active Control Recipe Unit Procedure or the related Unit (for
example, reactor, centrifuge, drier).
3.1.5.3. Batch operation
Identifies the active Control Recipe Operation.
3.1.5.4. Batch Phase
Identifies the active Control Recipe Phase.
Page 104 SITRANS LR 200 (PROFIBUS PA) – INSTRUCTION MANUAL
128
Out of Service (O/S)
16
Manual Mode (MAN)
8
Automatic Mode (AUTO)
7ML19985HP01