1.3. Device - Siemens SITRANS LR200 Instruction Manual

1.2.3. Master Reset
Note:
Following a Master Reset, complete reprogramming is required.
Values
1.2.4. Reset Fault
Resets the Fault message after an active fault has occurred and been corrected.
This is required only for faults listed as requiring a manual reset in the General
Fault Code list (see page 29).
To reset, key in the value of the fault code in question.
1.2.5. Menu Timer
Determines the length of time (in seconds) the device will stay in PROGRAM mode
without any key presses occurring.

1.3. Device

Manufacturer
References a specific manufacturer, usually the name of the company
responsible for the manufacture of this Field Device.
Product designation
Uniquely identifies the Field Device when combined with the Manufacturer
Identification and Device Type. This variable cannot be modified by the Host user.
Device Serial Num
Uniquely identifies the Field Device. This variable cannot be modified by the Host.
Order No.
The order number for this device.
Date of birth
Date of manufacture.
1.3.1. Software Revision
Corresponds to the software or firmware that is embedded in the Field Device.
1.3.2. Loader Revision
Corresponds to the software used to update the Field Device.
Page 86 SITRANS LR 200 (PROFIBUS PA) – INSTRUCTION MANUAL
Reset all parameters (except PROFIBUS address) to PROFIBUS PA
1
profile default values
2506 Warm Start: restart the device (this option is rarely used)
2712 Reset PROFIBUS address to 126
32768 Reset to manufacturer's default values (factory settings)
7ML19985HP01