Security
Local operation enable
Local Operation can be enabled or disabled via PDM. Go to Identification > Device > Local
Operation Enable and select the desired setting.
Remote operation enable
Remote Operation can be enabled or disabled via the hand programmer. To change the
setting:
•
Open Identification Menu, then scroll down to CONFIG.
•
Press Right ARROW
1. Identification
1.2. Configuration
•
To enable programming, set REMLOCK to 0. To disable programming, enter 1.
Write locking
Write locking prevents any changes to parameters, either via PDM or the hand
programmer, but still allows access to the device.
Open the menu Device – Write Locking, and select On or Off.
How to do a Master Reset
Open the menu Device– Master Reset to access the reset options, including Factory
Reset.
Fault Reset
This resets the Fault message after an active fault has occurred and been corrected.
A manual reset is required only for certain faults, identified by an asterisk (*) in the
General Fault Code list on page 29.
To reset, key in the value of the fault code in question.
Page 20
SITRANS LR 200 (PROFIBUS PA) – INSTRUCTION MANUAL
to open the Config Menu, then scroll down to REMLOCK.
1.2.2. Remote Lock
7ML19985HP01