Electronics Power Supply X524; Description Of The Leds On The Smc10 - Siemens SINAMICS S120 Equipment Manual

Supplementary system components and encoder system integration
7.3 Sensor Module Cabinet 10 (SMC10)
7.3.3.4

Electronics power supply X524

Table 7-21 Terminal block X524
Terminal
+
+
M
M
Max. cross-section that can be connected: 2.5 mm²
Type: Screw terminal 2 (see Appendix)
Note
The two "+" and "M" terminals are jumpered in the connector. This ensures the supply
voltage is looped through.
7.3.3.5

Description of the LEDs on the SMC10

Table 7-22 Description of the LEDs on the SMC10
LED Color
-
Green
Orange
RDY
Red
Green/
Red
Green/Orange
or
Red/Orange
7-26
Function
Electronics power supply
Electronics power supply
Electronic ground
Electronic ground
State
OFF
Steady light
Steady light
Steady light
Flashing light
2 Hz
Flashing light
2 Hz
Technical specifications
Voltage: 24 V (20.4 V – 28.8 V)
Current consumption: max. 0.35 A
Maximum current via jumper in connector: 20 A at 55°C
Technical specifications
Electronics power supply is missing or outside permissible
tolerance range.
The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component. Note:
LED is driven irrespective of the corresponding messages being
reconfigured.
Firmware is being downloaded.
Component recognition via LED is activated (p0144)
Note:
Both options depend on the LED status when component
recognition is activated via p0144 = 1.
Manual, (GH6), 03/2006 Edition, 6SL3097-2AL00-0BP0
Equipment Manual AC Drive