How To Access Diagnostic Information - Baldor 23H Series Installation & Operating Manual

Section 1
General Information

How to Access Diagnostic Information

Action
Apply Power
Display mode showing motor
speed.
Press DISP key 6 times Scroll to Diagnostic Information
screen
Press ENTER key Access diagnostic information.
Press DISP key Display showing control
temperature.
Press DISP key Display showing bus voltage.
Press DISP key Display showing % overload
current remaining.
Press DISP key Display showing real time opto
input & output states.
(0=Open, 1=Closed).
Press DISP key Display showing actual drive
running time.
Press DISP key Display showing operating zone,
voltage and control type.
Press DISP key Display showing continuous
amps; PK amps rating; amps/volt
scale of feedback, power base ID.
Press DISP key Display showing which Group1 or
2 expansion boards are installed
and recognized.
Press DISP key Display showing software version
and revision installed in the
control.
Press DISP key Displays exit choice.
5-2 Troubleshooting
Description Display
Logo display for 5 seconds.
No faults present. Local keypad
mode. If in remote/serial mode,
disable drive then press local for
this display.
Diagnostic Access screen.
First Diagnostic Information
screen.
XXXV
Opto Inputs states (Left);
Opto Outputs states (Right).
HR.MIN.SEC format.
ID is a hexadecimal value.
In this case, no expansion boards
are installed.
Press ENTER to exit diagnostic
information.
Comments
MN723