Display Mode; Adjusting Display Contrast; Display Mode Screens - Baldor 23H Series Installation & Operating Manual

Section 1
General Information

Display Mode

Control Operation

Adjusting Display Contrast

Action
Apply Power
Press DISP Key
Press SHIFT SHIFT
Press Y or B Key
Press ENTER

Display Mode Screens

Action
Apply Power
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
Press DISP key
4-2 Programming & Operation
The control is in the DISPLAY MODE at all times except when parameter values are
changed (Programming mode). The Keypad Display shows the status of the control as in
the following example.
Motor Status
The DISPLAY MODE is used to view operating status, Diagnostic INFO, the Fault Log
and to adjust the Display contrast. The description of how to do these tasks are
described on the following pages.
When AC power is applied to the control, the keypad should display the status of the
control. If there is no visible display, use the following procedure to adjust the contrast of
the display. Contrast may be adjusted in display mode when motor is stopped or running.
Description
No visible display
Places control in display mode
Allows display contrast
adjustment
Adjusts display intensity
Saves level of contrast and exits
to display mode
Description
Display mode showing motor
speed.
Display Frequency
Display Current
Display Voltage
Combined Display
Screen to enter Fault Log
Screen to enter Diagnostic Menu
Output Condition
Value and Units
Display
Typical display
Display
Logo display for 5 seconds.
No faults present. Local keypad
mode. If in remote/serial mode,
press local for this display.
First Display Mode Screen.
Comments
Comments
MN723