Table of Contents
Advertisement
Control Installation
Keypad Installation Procedure
3-2 Receiving & Installation
The control must be securely fastened to the mounting surface at the mounting holes.
Shock Mounting
If the control will be subjected to levels of shock greater than 1G or vibration greater than
0.5G at 10 to 60Hz, the control should be shock mounted.
1.
Refer to the optional remote keypad installation procedure and mount the
keypad.
2.
Connect the keypad cable to the keypad connector on the main control board.
Refer to Figure 3-30 for the connector location.
MN723
Advertisement
Table of Contents
Troubleshooting
