How To Access Diagnostic Information - Baldor 29M Installation And Operating Manual

Section 1
General Information

How to Access Diagnostic Information

Action
Apply Power
Display mode showing output
frequency
Press DISP key Display mode showing motor
speed (based on output
frequency).
Press DISP key Scroll to diagnostic info block.
Press ENTER key Access diagnostic information.
Press DISP key Display mode showing control
temperature.
Press DISP key Display mode showing bus
voltage.
Press DISP key Display mode showing %
overload current remaining.
Press DISP key Display mode showing opto
inputs & outputs states.
Press DISP key Display mode showing actual
drive running time since last
power up.
Press DISP key Display mode showing operating
zone, voltage and control type.
Press DISP key Display mode showing continuous
amps; PK amps rating; amps/volt
scale of feedback, power base ID.
Press DISP key Display mode showing motor
shaft revolutions from the REV
home set point.
Press DISP key Display mode showing parameter
table selected.
Press DISP key Display mode showing software
version and revision installed in
the control.
Press DISP key Displays exit choice.
MN1230
Description Display
Logo display for 5 seconds.
No faults present. Local keypad
mode. If in remote/serial mode,
press local for this display.
Displays commanded speed,
direction of rotation, Local/
Remote and motor speed.
Displays operating temperature in
degrees C.
Opto Inputs states (Left);
Opto Outputs states (Right).
HR.MIN.SEC format.
XXX-X.XX
Press ENTER to exit diagnostic
information.
Comments
Troubleshooting 5-5