Display Mode; Adjusting Display Contrast - Baldor 29M Installation And Operating Manual

Display Mode

Control Operation

Adjusting Display Contrast

Action
Apply Power
Press DISP Key
Press SHIFT SHIFT
Press Y or
Key
Press ENTER
4-2 Programming & Operation
During normal operation, the control is in the DISPLAY MODE. In this mode, the Keypad
Display shows the status of the control as in the following example.
Motor Status
The DISPLAY MODE is used to view DIAGNOSTIC INFO and the FAULT LOG. The
description of how to do these tasks are described on the following pages.
When AC power is applied to the control the keypad should display the status of the
control. If there is no visible display, use the following procedure to adjust the contrast of
the display. (Contrast may be adjusted in display mode when motor is stopped or
running).
Description
No visible display
Places control in display mode
Allows display contrast
adjustment
Adjusts display intensity
Saves level of contrast and exits
to display mode
Output Condition
Value and Units
Display
Typical display
Comments
MN1230