Trim Set - Ko Propo EX-RR Instruction Manual

TRIM SET

The convenient function that can set trim and travel
while operating steering wheels.
▶ STEER AUTO TRIM
① Move the cursor to "SET" and push the ENT key,
"SET" will start blinking.
※ At this time, the steering trim becomes 0
forcibly.
② Hold the steering wheel of the transmitter to the
position that you want to make neutral.
Set the steering neutral position by pushing the
ENT key while holding the position.
TRIMSET
TRIMSET トリムセット
STEER AUTO TRIM STEER AUTO TRIM
ｽﾃｱﾘﾝｸﾞｵｰﾄﾄﾘﾑ
STEER AUTO BALANCE STEER AUTO BALANCE
ｽﾃｱﾘﾝｸﾞ LEFT LEFT ﾋﾀﾞﾘ
RIGHT
ｵｰﾄﾊﾞﾗﾝｽ RIGHTﾐｷﾞ
As for this function, only the numerical value of the
P
steering trim changes. Does not influence the numerical
value of the steering subtrim.
After pushing "SET", the steering servo moves because
the neutral position has changed.
Release the steering handle, the servo moves to the new
neutral position.
▶ STEER AUTO BALANCE LEFT
① Move the cursor to "SET" and push the ENT key,
"SET" will start blinking.
※ At this time, the steering travel(L) becomes
100 forcibly.
② Hold the steering wheel of the transmitter to the
position that you want to make the Left end point.
Set the steering travel(L) position when pushing
the ENT key while holding the position.
As for this function, only the numerical value of the
P
steering tavel(L) changes. Does not influence the
numerical value of the steering travel and travel(R).
When the quantity of movement is short, set automatic
balance again after increasing steering travel.
After pushing "SET", the steering servo moves because
the travel(L) position has changed.
Release the steering handle, the servo moves to the
neutral position.
Use of Steering auto balance may increase load on the
servo and cause increased wear or damage. Check the
servo while adjusting.
When operating the steering wheel to the right in
steering auto balance(L), it will not set correctly. Be
careful to the direction of operation.
SET
SET
SET SET
SET SET
▶ STEER AUTO BALANCE RIGHT
① Move the cursor to "SET" and push the ENT key,
"SET" will start blinking.
※ At this time, the steering travel(R) becomes
100 forcibly.
② Hold the steering wheel of the transmitter to the
position that you want to make the Right end
point. Set the steering travel(R) position when
pushing the ENT key while holding the position.
As for this function, only the numerical value of the
P
steering tavel(R) changes. Does not influence the
numerical value of the steering travel and travel(L).
When the quantity of movement is short, set automatic
balance again after increasing steering travel.
After pushing "SET", the steering servo moves because
the travel(R) position has changed.
Release the steering handle, the servo moves to the
neutral position.
Use of Steering auto balance may increase load on the
servo and cause increased wear or damage. Check the
servo while adjusting.
When operating the steering wheel to the left in steering
auto balance(R), it will not set correctly. Be careful to
the direction of operation.
35