How To Attach Xpansion Unit - Ko Propo EX-RR Instruction Manual

Hide thumbs Also See for EX-RR:
Table of Contents

Advertisement

● Installation of Xpansion unit
Xpansion unit can be mounted facing the
front or the side. The factory setting is
mounted to the front.
Be careful to not misuse the M2.6-6BH and TP2.6-
8BH screws.
Remove the connector cover before use.
Xpansion unit can be mounted in two different
P
directions using the monitor base and bracket.
A ▼:setting to the front
① Attach a monitor base parallel to Xpansion
 unit. ※ Factory setting.
Attention to the marker.
screw used.
M2.6-6BH
x 2
② Attach the monitor bracket to the master
 unit. ※[ A ▼]mark to the steering side.
Connect the wire of the
Xpansion unit to the
master unit.
screw used.
2.6-8BH
Self tapping
screws
x 4
③ Attach expansion unit to a master unit.
1
While matching the edge of the base with
the dent of the bracket, slide it until the
Xpansion unit locks.
screw used.
M2-6
cap screw
x 1
A
1
2
2
Set M2-6 Cap Screw.
▼ B:when mounting sideways
① Attach the monitor base at a right angle to
 Xpansion Unit. ※ Different Factory setting.
Attention to the marker.
screw used.
M2.6-6BH
x 2
② Attach the monitor bracket to the master unit.
  ※ Apply[ B ▼] mark to the steering side.
Connect the wire of the
Xpansion unit to the
master unit.
screw used.
2.6-8BH
Self tapping
screws
x 4
③ Attach the Xpansion unit to the master unit.
 ※ Attach the monitor base and bracket as
  shown in figure A ③ .
How to disassemble the Xpansion unit.
1.Remove M2-6 Cap Screw.
2.Slide the Xpansion like shown in the figure
 below and take off.
※ The disassembly method is the same as side
 and front positions.
screw used.
M2-6
cap screw
x 1
When assembling or disassembling the Xpansion unit to
EX-RR, please switch off the EX-RR.
6
Nut Holder
B
2
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents