www.ti.com
1.5
DLP LightCrafter 4500 Jumpers
The DLP LightCrafter 4500 has jumper options to disable the onboard LED driver, control voltages of the
LED signals to an external board, and control the trigger input and output voltages. This section lists all
the jumpers on the DLP LightCrafter 4500 driver board.
These jumpers require a 2-mm jumper, like Sullins Connector Solutions
number S3404-ND.
•
J8: EDID write protect disable jumper. Place this jumper to reprogram the EDID EEPROM (U2) using
2
I
C commands through the mini-HDMI connector. Remove the jumper when programming of the EDID
is complete. The EDID is programmed at the factory with resolutions of 1280 x 800 and 912 x 1140.
•
J10: DLPC350 TRIG1_IN voltage selection. See to
– Jump across pins 3 to 4 for 3.3 V
– Jump across pins 5 to 6 for 1.8 V
•
J12: DLPC350 TRIG2_IN voltage selection. See to
– Jump across pins 3 to 4 for 3.3 V
– Jump across pins 5 to 6 for 1.8 V
DLPU011E – July 2013 – Revised September 2015
Submit Documentation Feedback
Figure 1-9. DLP LightCrafter 4500 Jumper Locations
Copyright © 2013–2015, Texas Instruments Incorporated
DLP LightCrafter 4500 Jumpers
Figure 1-9
depicts the locations of these jumpers.
SPN02SYBN-RC, Digi-Key part
®
Figure
1-10.
Figure
1-10.
DLP LightCrafter 4500 Module Overview
17