Dlp Lightcrafter 4500 J10 And J12 Voltage Jumpers; Dlp Lightcrafter 4500 J13 And J15 Voltage Jumpers - Texas Instruments DLP LightCrafter 4500 User Manual

DLP LightCrafter 4500 Jumpers
Figure 1-10. DLP LightCrafter 4500 J10 and J12 Voltage Jumpers
• J13: DLPC350 TRIG1_OUT voltage selection. See to
– Jump across pins 3 to 4 for 3.3 V
– Jump across pins 5 to 6 for 1.8 V
• J15: DLPC350 TRIG2_OUT voltage selection. See to
– Jump across pins 3 to 4 for 3.3 V
– Jump across pins 5 to 6 for 1.8 V
Figure 1-11. DLP LightCrafter 4500 J13 and J15 Voltage Jumpers
• J18: DLPC350 HOLD_IN_BOOT. Jump across this header to hold the DLPC350 in bootloader mode.
18
DLP LightCrafter 4500 Module Overview
Copyright © 2013–2015, Texas Instruments Incorporated
Figure 1-11.
Figure 1-11.
DLPU011E – July 2013 – Revised September 2015
Submit Documentation Feedback
www.ti.com