Input Trigger Connector Pins; Output Trigger Connector Pins - Texas Instruments DLP LightCrafter 4500 User Manual

This chapter describes the connector pins of the DLP LightCrafter 4500 module.
7.1 Input Trigger Connectors
Table 7-1 lists the input trigger connector (J11) pins. The trigger inputs have hysteresis. Two matching six-
pin, 1.25-mm connector part numbers are:
• Molex part number: 51021-0600
• Digi-Key part number: WM1724-ND
The corresponding connector terminal (crimp) part numbers are:
• Molex part number: 50079-8100
• Digi-Key part number: WM2023-ND
7.2 Output Trigger Connectors
Table 7-2 lists the output trigger connector (J14) pins. Two matching six-pin, 1.25-mm connector part
numbers are:
• Molex part number: 51021-0600
• Digi-Key part number: WM1724-ND
The corresponding connector terminal (crimp) part numbers are:
• Molex part number: 50079-8100
• Digi-Key part number: WM2023-ND
64
Connectors
Table 7-1. Input Trigger Connector Pins
Description Pin
Trigger In 1 supply 1
External or internal 1.8-V and 3.3-V
selectable at J10
Trigger In 1 2
Ground 3 Ground
Trigger In 2 supply 4
External or internal 1.8-V and 3.3-V
selectable at J12
Trigger In 2 5
Ground 6 Ground
Table 7-2. Output Trigger Connector Pins
Description Pin
Trigger Out 1 supply 1
Trigger Out 1 2
Ground 3
Trigger Out 2 supply 4
Trigger Out 2 5
Ground 6
Copyright © 2013–2015, Texas Instruments Incorporated
DLPU011E – July 2013 – Revised September 2015
Supply Range
Supply Range
1.8-V and 3.3-V selectable at J13
Ground
1.8-V and 3.3-V selectable at J15
Ground
DLPU011E – July 2013 – Revised September 2015
Chapter 7
Connectors
Submit Documentation Feedback