What is in the LightCrafter 4500 EVM?
– TL7712: Programmable time delay for power-supply sequencing
•
TFP401: Digital Receiver for DVI to 24-bit parallel RGB interface
•
TS3USB2221A: ESD-protected high-speed USB multiplexer
•
SN74AVC32T245: 32-bit dual supply bus transceiver for system board interface
1.2.3 Embedded Processor Interface
The DLP LightCrafter 4500 driver board allows the connection of a PandaBoard ES. See,
1.3
Other Items Needed for Operation
The DLP LightCrafter 4500 module is a flexible, ready-to-use EVM. However, the DLP LightCrafter 4500
EVM does not ship with cables, power supply, or additional hardware components. To use the EVM, the
user needs the following:
•
Power supply:
– Nominal voltage: 12-V DC
– Typical current: 6 A
– Maximum current: 7 A
– DC connector size:
•
Inner diameter: 2.5 mm
•
Outer diameter: 5.5 mm
•
Shaft: 9.5-mm female, center positive
– Efficiency level: V
– A recommended power supply is
•
USB cable: A to mini-B USB cable
•
Optional:
PandaBoard 4500
14
DLP LightCrafter 4500 Module Overview
Digi-Key part number 62-1186-ND
Copyright © 2013–2015, Texas Instruments Incorporated
Chapter
, or equivalent.
DLPU011E – July 2013 – Revised September 2015
Submit Documentation Feedback
www.ti.com
6.