Table of Contents
Advertisement
10.2.
SETTING TYPICAL CONFIGURATIONS
In order to facilitate this task, the instrument is provided with the following two pre-set
recording modes:
1. Default Configuration: this is comprehensive which should fit most cases.
2. Typical Configuration: it is possible to select recording with pre-setting parameters for
the following situations:
EN50160
SURGES & DIPS
HARMONICS
START-UP
POWER & ENERGY
10.2.1. Default Configuration
The default configuration of instrument consists in the following parameters settings:
ANALYZER CONFIG:
System:
Frequency:
Current Range:
Clamp Type:
TV Ratio:
Password:
RECORDER CONFIG:
Start:
Stop:
Integration period:
Recording of harmonics:
Recording of Voltage anomalies (voltage Sag and Surge) :
Voltage Reference for Sag and Surge detection:
Upper Limit for Sag and Surge detection:
Lower Limit for Sag and Surge detection:
Selected voltages:
Selected voltage harmonics:
Selected currents:
Selected current harmonics:
CO-GENERATION:
Powers, Pf and cosϕ selected:
Energies:
If the user changed the instrument's settings, the user can quickly resume the above
configuration using the RESET option (see paragraph 5.4).
Setting parameters for Networks Quality in compliance with EN 50160
standard (see paragraph 16.11.2).
Setting parameters for Voltage Anomalies detection (surges, dips, break,
etc.) (See paragraph 16.10).
Setting parameters for Harmonics Analysis of Voltage and Current (see
paragraph 16.11).
Setting parameters for Start-Up motors and electrical devices.
Setting parameters for Power and Energy measures (see paragraph 16.12).
Page 89 of 131
SINGLE
1000A
enabled
MANU (the recording is started
1 minute after pressing
the START/STOP key)
MANU
15min
THD, 01, 03, 05, 07
THD, 01, 03, 05, 07
VR2250
50Hz
STD
1
ON
ON
230V
6%
10%
V1
I1
OFF
P1
Q1i
Q1c
S1
Pf1
dpf1
Ea1
Eri1
Erc1
Advertisement
Table of Contents
