Table of Contents
Advertisement
8.7.2. "METER" mode
In this mode the instrument shows the below screens according to the settings made as
per paragraph 8.1.
The symbols used are described in Tab. 4.
For eventual messages displayed see Appendix 1 – MESSAGES DISPLAYED.
Following keys are enabled:
F2:
F3/F4:
SAVE:
ENTER/HOLD:
MENU:
START/STOP:
27.09.00
ENERGY
SINGLE PHASE
Ea1
= 0.000 kWh
Erc1
= 0.000 kVARh
Eri1
= 0.000 kVARh
P1
= 36.38 kW
Q1
= 6.375 kVAR
S1
= 36.94 kVA
dpf1
=
Meas Time: 00:00:00
MEAS PG-
Example of screen
to start / stop immediately a direct energy measurement. The
energy counters will start increasing proportionally to the active
power absorbed by the load.
The results obtained cannot be memorised.
If the active power is negative the counters will not increase.
to pass to previous/next function respectively.
to save in the instrument memory a record of "Smp" type (see
paragraph 9.2) containing the instantaneous values of voltage and
current present on the instrument inputs. This function is disabled
during a recording.
to enable/disable the HOLD function (updating interruption) of the
displayed data. All the previous functions remain however available.
When the HOLD function is enabled, the word
When this function is enabled it's not possible to record or take an
energy measurement. This function is disabled during a recording or
an energy measurement.
to enter in the MENU mode and change the instrument settings (see
paragraph 8.1 and 8.2). It's not possible to enter the configuration
MENU during a recording or an energy measurement.
to record selected parameters according to the instrument's settings
(see chapter 10).
Page 84 of 131
17:35:12
0.98 i
PG+
VR2250
HOLD
is displayed.
Advertisement
Table of Contents
