Basic Setting: Recorder Config - MARTINDALE VR2250 User Instruction Manual

8.2.

BASIC SETTING: RECORDER CONFIG

Place the rotary switch in the ANALYSER position, press the MENU key, using the F1/F2
keys select the RECORDER CONFIG and press the ENTER Key.
This option allows you to check and eventually modify the recording parameters and the
selected parameters (up to a maximum of 62+Frequency). If the number of selected
values exceeds 63 the message
CONFIG mode is divided into 4 separate sub-screens:
st
1 screen: This screen allows you to set the START/ STOP mode (AUTO or
MANUAL), the START and STOP time if AUTO mode is selected, the
Integration Period value, the Enabling/Disabling of Voltage Anomalies
detection, the Enabling/Disabling of Harmonics detection. Press ENTER to
confirm the settings and pass to the following screen.
Press ESC to leave the Menu without modifying the existing parameters.
nd screen: This screen is devoted to the settings relevant to the VOLTAGE recording.
2
Press ENTER to confirm the settings and pass to the following page.
Press ESC to leave this screen without modifying the existing parameters.
From this page you can enter the sub-screen "Harmonics" which permits to
select the voltage harmonics to be recorded.
Press ENTER to confirm the settings and leave the "Menu Harmonics".
Press ESC to leave the "Menu Harmonics" without modifying the existing
parameters.
rd
screen: This screen is devoted to the settings relevant to the CURRENT recording.
3
Press ENTER to confirm the settings and pass to the following screen.
Press ESC to leave this screen without modifying the existing parameters.
From this screen you can enter the sub-screen "Harmonics" which permits to
select the current harmonics to be recorded.
Press ENTER to confirm the settings and leave the "Menu Harmonics".
Press ESC to leave the "Menu Harmonics" without modifying the existing
parameters.
th
4 screen: Menu composed of two sub-screens devoted to the selection of the
POWERS and ENERGIES to be recorded. From this screen you can enter
the sub-screen "POWER" and "ENERGY" which permits the user to select the
parameters to be recorded.
Selecting the active powers for the recording, the corresponding active
energies will be automatically selected.
Selecting the reactive powers for the recording, the corresponding reactive
energies will be selected.
Press ENTER to leave this screen confirming the modifications made.
Press ESC to leave the "Menu" without modifying the existing parameters.
The various screens of the "RECORDER CONFIG" can be schematised as follows:
"too many param" will be displayed. The RECORDER
Page 65 of 131
VR2250