Table of Contents
Advertisement
4.1.
DISPLAY DESCRIPTION
The display is a graphic module with a resolution of 128 x 128 pixels
The first line of the display shows the date and time. If not correct, you can set these
according to the procedure described at paragraph 5.2.
On the top right corner of the display you can always see the battery indicator and, if the
external power supply adapter (optional code MAR####) is connected, the corresponding
symbol.
LOWΩ
----Ω
---mA
AUTO 0.11Ω
FUNC
These symbols will be omitted in the following illustrations.
4.2.
INITIAL SCREEN
When turning on the instrument by pressing ON/OFF, this screen will appear for a few
seconds:
Here you can see:
• Serial number of the instrument (SN :)
• Firmware software release (V.X.XX :)
• transmission speed through serial RS232 (Baud Rate)
• Calibration date (CALIBRATION :)
4.3.
BACKLIGHT FUNCTION
When instrument is turned on, pressing briefly the ON button, the backlight will be
enabled. The light will be automatically turned off after 5 seconds.
If the batteries are too low the instrument will disable automatically the backlight function.
05.06.01
Ω
----
R+
R-
----Ω
---mA
CAL
Veritest
2250
MARTINDALE
SN:00000000
BAUD RATE 57600
CALIBRATION DATE
01.01.06
Page 11 of 131
27.09.00
SINGLE PHASE
VOLTAGE
V1
= 230.2 V
Vpk1
= 325.5 V
ThdV
= 0.0
freq
= 50.0 Hz
HARM
WAVE
V: X.XX
VR2250
17:35:12
%
Advertisement
Table of Contents
