Table of Contents
Advertisement
9. SAVING RESULTS
The SAVE button can be used to store the displayed results related to the rotary switch
position:
SAFETY TEST and for AUX rotary switch position: pressing this key the instrument will
store the displayed result generating a corresponding record in the SAFETY TEST
MEMORY (see paragraph 11.1)
ANALYSER rotary switch position: pressing this key the instrument will store the
displayed result generating a "Smp" record in the ANALYZER MEMORY (see
paragraph 11.2)
Please note that saving results is different from recording.
9.1.
SAVING SAFETY TEST RESULTS
After a SAFETY TEST (function LOW Ω , M Ω , RCD, LOOP, Phase sequence, EARTH) or
during a real time measurement in AUX position the user can press the SAVE button to
store the displayed result.
The REMINDER
PLACE parameter is
not related to the
Measurement Order
Number and can help
to remind the user the
place where the
measurement was
performed.
The following keys are available:
F3, F4:
to adjust the REMINDER PLACE.
SAVE:
to store the test result associating to the actual REMINDER PLACE
ESC:
to quit this mode without saving.
9.2.
SAVING DISPLAYED VALUES OF ANALYSER FUNCTION
During a Real Time measurement (in ANALYSER function) if the user presses the SAVE
button, a "Smp" record will be generated in the "ANALYZER MEMORY". This file contains
the Voltage and Current values present at the instrument's input when the user pressed
the SAVE key.
Downloading these values to a PC (using the management Software) the Power, Energy,
Harmonics; etc values can be calculated and displayed as well.
05.06.01
SAVE IN LOC. 006
OK? (SAVE/ESC)
REMINDER PLACE:009
↑
Page 87 of 131
Memory Location
REMINDER PARAMETER
↓
VR2250
Advertisement
Table of Contents
