Initial Settings; How To Adjust The Contrast; How To Set Date And Time; How To Set The Language - MARTINDALE VR2250 User Instruction Manual

5. INITIAL SETTINGS

By pressing the MENU key the following screen will be displayed:
It's not possible to enter the MENU during a recording or a Real Time Energy
measurement. Pressing this button during a recording the display will show main recording
parameter (see paragraph 10.3)
5.1.

HOW TO ADJUST THE CONTRAST

By pressing the multifunction keys F1 and F2, position the cursor on the CONTRAST item
and confirm it by pressing the ENTER key.
By pressing the multifunction keys F3 and F4, adjust the contrast (higher values
correspond to a higher contrast while lower values correspond to a lower contrast) and
press the ENTER key to SAVE the change or press ESC to quit without saving.
This setting will remain unchanged after turning off the instrument.
5.2.

HOW TO SET DATE AND TIME

By pressing the multifunction keys F1 and F2, position the cursor on the DATE&TIME item
and confirm it by pressing the ENTER key.
The time is expressed as hh:mm (2 digits for hours, 2 digits for minutes) 24 hour clock.
Press the ENTER key to SAVE the change or press ESC to quit without saving.
This setting will remain unchanged also after turning off the instrument.
5.3.

HOW TO SET THE LANGUAGE

By pressing the multifunction keys F1 and F2, position the cursor on the LANGUAGE (EN)
item and confirm it by pressing the ENTER key.
By pressing the multifunction keys F1 and F2, position the cursor on the desired language
and press the ENTER key to SAVE the change or press ESC to quit without saving.
This setting will remain unchanged after turning off the instrument.
MENU GENERAL
SAFETY TEST MEMORY
ANALYZER MEMORY
RESET
ANALYZER CONFIG
RECORDER CONFIG
CONTRAST
DATE&TIME
LANGUAGE
↓ ↑
Page 12 of 131
VR2250