Table of Contents
Advertisement
8.4.2. "METER" mode
In this mode the instrument shows the below screen according to the settings made as per
paragraph 8.1.
The symbols used are described in Tab.1
For eventual messages displayed see Appendix 1 – MESSAGES DISPLAYED.
Following keys are enabled:
F1:
F2:
F3/F4:
SAVE:
ENTER/HOLD:
MENU:
START/STOP:
27.09.00
VOLTAGE
SINGLE PHASE
V1
Vpk1
ThdV
Freq
HARM. WAVE
Example of screen
to pass to "HARMONIC" mode (see paragraph 8.4.3).
to pass to "WAVE" mode (see paragraph 8.4.4).
to pass to previous/next function respectively.
to save in the instrument memory a record of "Smp" type (see
paragraph 9.2) containing the instantaneous values of voltage and
current present on the instrument inputs. This function is disabled
during a recording.
to enable/disable the HOLD function (updating interruption) of the
displayed data. All the previous functions remain however available.
When the HOLD function is enabled, the word
When this function is enabled it's not possible to record or take an
energy measurement. This function is disabled during a recording or
an energy measurement.
to enter in the MENU mode and change the instrument settings (see
paragraph 8.1 and 8.2). It's not possible to enter the configuration
MENU during a recording or an energy measurement.
to record the selected parameters according to the instrument's
settings (see chapter 10).
Page 73 of 131
17:35:12
= 230.2 V
= 325.5 V
= 0.0
%
= 50.0 Hz
PG-
PG+
VR2250
HOLD
is displayed.
Advertisement
Table of Contents
