Attach the left and right rack mount rails (A) to the switch, and secure the chassis in the rails
Step 1.
by screwing 2 flat head Phillips screws (D) in the designated points on each side (a total of 4
screws). See
Install 8 cage nuts (C) in the desired 1U slots of the rack: 4 cage nuts in the non-extractable
Step 2.
side and 4 cage nuts in the extractable side. Note that while each rack U (unit) consists of
36
Figure 27: Installation Options
Figure
28. To tighten the screws, use a torque of 1.5±0.2 Nm.
Figure 28: Attaching the Rails to the Chassis
Mellanox Technologies
Rev 1.9