Table 1 Multinode Connections - Honeywell OW-CDX050 User Manual

Feature or Connector
ETHERNET
24V DC POWER
IR PORT
FHSS ANTENNA
(Type N-female connector)
OR
FIELD I/O ANTENNA
(Type N-female connector)
ANTENNA
(Two reverse polarity
Type N-female connectors)
OR
AP ANTENNA and
MESH ANTENNA
(Two Type
N-female connectors)
Operating/Status indicators
LEDs
R110
6/08
The Multinode/Wireless System Gateway

Table 1 Multinode connections

¾-inch conduit connection with four cable pigtails.
•
Two Ethernet cables - (Labelled WLAN1 and
WLAN2) Either Ethernet cable can be used to:
−
Connect to a PC for initial setup.
−
Connect the WSG to the plant control
network
−
Connect Ethernet-based devices, such as
switches, controllers, cameras, etc. to a
multinode or WSG.
Note: Both Ethernet ports are wired to one switch
with a single MAC Address.
•
A red (or grey) cable - power cable
•
A green/yellow grounding conductor.
Infrared sensor port used for communication with the
authentication device.
Provides connection of an omni-directional antenna or
optional remote antennas for communication with
various wireless field devices.
Provides connection for two 5dBi omni-directional or
optional remote antennas that enable communication
between the multinodes, WSGs, other multinodes in
the network and other WiFi devices.
Six indicators located on the top of the multinode
enclosure and indicate operating status. These LEDs
are described in Table 2 on page 18.
OneWireless Multinode User's Guide
Physical description
Description
17