Table of Contents
Advertisement
LED Indicator
NOTE: A fault in the multinode is indicated when WLAN1 and WLAN2 LEDs blink
simultaneously. The multinode software has detected a fault with the encryption
algorithm or the device configuration has not passed the integrity check. See
Troubleshooting
Multinode specificiations
Specification
Enclosure
Power requirements
Hardware Specification:
External Ports:
WAN Ethernert setting:
R110
6/08
with the gateway application and the WSG has been
configured in Wireless Builder.
•
Multinode - LED behavior is undetermined.
for more information.
Table 3 Multinode specifications
Certifications: Class 1 DIV2/ZONE2 hazardous area.
Physical dimensions: 9.25 in. x 8.25 in. x 3.0 in.
Weight: 7.0 lbs
Power input: +24 Volts dc, -15% +10% (20.4 to 26.4Vdc)
Current requirement: 1.5 Amps, maximum.
Power output: 25 Watts, maximum
CPU: XScale IXP425 @ 533 MHz
8 MB flash
64 MB SDRAM
Two 10/100 Mbps WAN Ethernet ports. See Note.
3 external antenna ports.
Note: Both Ethernet ports are wired to one switch with a
single MAC Address.
Fixed IP
Supports: IEEE 802.3u Fast Ethernet
OneWireless Multinode User's Guide
The Multinode/Wireless System Gateway
Multinode specificiations
When lit it ...
Description
IP66 waterproof
19
Advertisement
Table of Contents
