Table of Contents
Advertisement
Configuration
Wireless Access Point Configuration
Follow the steps to enter information for the multinode configuration. See Table 6 and
Table 7 below for the details in setting these fields.
Step
1
Click on the Wireless Access Point - General at the left of the screen to call
up the Wireless Access Point screen.
2
MAC Address is displayed 00:0B:6B:0A:45:6C (WistronNew) as in the
example in Figure 5.
3
Enter the SSID for this network.
Note: If you are using an SSID for a wireless LAN, enter it here and in the
setup of each wireless client (multinode) in the network. The SSID must be
the same for the WSG and each wireless client in the network for them to
communicate.
4
Choose the Wireless Mode communications protocol to be used for this
network from selections in the drop down menu.
5
Choose the Channel No from the list in the drop down selections. See
Channel number
Click Apply after selecting the channel number.
6
The Select the optimal channel button may appear. See
selection
An option may appear for the AP to Automatically select the optimal
channel at bootup. You can choose Yes or No.
7
Choose Auto for the TxPower Mode field. See
below.
8
When choosing the Advanced options, you can use the default selections, or
choose values appropriate for your wireless network. See Table 7 for
description of these Advanced options.
The following values are the defaults for these fields:
Beacon Interval: 100
RTS Threshold: 2346
DTIM: 1
Basic Rates: 1, 2, 5.5, 11 Mbps (basic rates available depend upon Wireless
Mode selection)
48
description below.
below for an explanation of this function.
OneWireless Multinode User's Guide
Action
Optimal channel
TxPwr Mode
description
R110
6/08
Advertisement
Table of Contents
