Table of Contents
Advertisement
System Configuration - Operating Mode
The System Configuration - Operating Mode screen allows you to set the unit to operate
as either a WSG or a multinode. Note that if you change modes from multinode to WSG,
your configuration is not lost.
Follow the steps to make selections for the operating mode.
Step
1
Click on the System Configuration - Operating Mode at the left of the
screen to call up the Operating Mode screen.
2
Choose one of the following Operation Modes:
•
L1/L2 Gateway - select when the multinode is to be used as a WSG to
connect the wireless network to a Level 1 or Level 2 wired network
•
L3/L4 Gateway - select when the multinode is to be used as a WSG to
connect the wireless network to a Level 3 or Level 4 wired network
•
Multinode - select when the multinode is to be used as a multinode to
communicate with the wireless field devices.
3
Choose Time Sync Root.
Note: When using the network time synchronization function (in the General
screen) among the mesh nodes, configure only one mesh node as the time
sync root/source. The time source of this node should be set to either
Manual or From NTP Server in the
4
When you have completed entries for all fields on the screen, click Apply.
R110
6/08
Action
General
OneWireless Multinode User's Guide
Configuration
Multinode Configuration Tool screens
screen.
45
Advertisement
Table of Contents
