Table of Contents
Advertisement
NOTE 1: There are two WAN ports - WAN 1, which can be set through the WAN Link
field, and WAN 2 which is always fixed to Auto. The WAN Link field only sets the link
speed and duplex mode for the WAN 1 port.
Wireless Access Point Configuration
Wireless Setup allows your computer's PC card to communicate with the access point
(multinode). Once you have completed wireless access point configuration, you can
complete the rest of the configuration wirelessly, assuming that you have installed and
configured a wireless PC card on your computer. (If you have not done so, you will have
to do that to establish communications. Follow the manufacturer's instructions to set up
the PC card on each wireless device that will be part of the WLAN.)
General screen
Wireless Access Point - General screen shown in Figure 5 lists the MAC Address of the
Gateway card. Note that this is not the MAC Address that will be used for the Bridge
SSID for mesh setup, which is found on the Wireless Bridge - General screen.
Figure 5 Wireless Access Point - General configuration screen
R110
6/08
OneWireless Multinode User's Guide
Configuration
Wireless Access Point Configuration
47
Advertisement
Table of Contents
