Nfn Gateway Cable Connections; 1: Ip Cable Connections - Honeywell NOTIFIER ONYXWorks NFN Gateway Installation & Operation Manual

NFN Gateway Embedded Installation

2.7 NFN Gateway Cable Connections

2.7.1 IP Cable Connections
This connection is the NFN Gateway to your IP network (Internet or Intranet). The supplied
PNET-1 surge suppressor must be used between the NFN Gateway PC board and your network.
Step 1. Plug one end the RJ45 cable into the NFN Gateway PC board and the other into the square
Step 2. Connect your IP network RJ45 cable into the round end of PNET-1.
Step 3. After the IP network configuration is made, perform
To Internet or Intranet
NOTE: If you are configuring the NFN Gateway using a PC that is not connected to your IP
network, then you can leave the connection between the PC board and the PNET-1 disconnected
until the gateway configuration is complete (refer to
Gateway" on page
24
end of the PNET-1.
Connection" on page 25.
Customer Supplied Cable
PNET-1 surge suppressor
Figure 2.8 IP Cable Connection
30.)
NFN Gateway Installation & Operation Manual - P/N: 52306:Rev: D 06/01/07
NFN Gateway Cable Connections
"Gateway Network Cable
PC board to PNET-1
"Connect the Configuration PC to the NFN
PC Board