Table 10 Manual Mesh Screen Options - Honeywell OW-CDX050 User Manual

Table of Contents

Auto Mesh

Parameter

Broadcast SSID

Signal Strength MAC

Manual mesh options

When Manual Mesh mode is selected on the Wireless Mesh - General screen, you can

manually select MAC address of a node that represents the signal strength LED and

enable or disable spanning tree protocol. You can also add and delete remote AP's

(multinode's) MAC addresses.

Manual Mesh

Parameter

Mesh Mode

Signal Strength

LED MAC

R110

6/08

Option

Disable/Enable

When enabled, the SSID of the network is

broadcast so that any client using the SSID

can associate with the multinode.

When disabled, the multinode hides the

SSID in outgoing beacon frames to prevent

stations from obtaining the SSID through

passive scanning. Also, the bridge doesn't

send probe responses to probe requests

with unspecified SSIDs when disabled.

The MAC address of a multinode. The

signal strength of the link between this

multinode and the other multinode (indicated

in the Signal Strength MAC field) will be

represented by the WLANSS LED located

on the front of the multinode. The WLANSS

LED will blink at a rate proportional to the

signal strength of the link.

Note that the MAC address may or may not

be the addresss of the bridge link used in

the mesh network. Normally, this parameter

is not configured and is used only as a

diagnostic aid.